Cantilever Shaft Screw Mount, Tapped End

The cantilever pin can be used as the pivot point of rotary parts such as idlers. The pivot point is similar to the axis of a hinge, and the connected parts can make rotary movements.

Type	D[Φ:mm]	Equivalent Material	Surface Treatment
E-FXHB	6~20	General structural steel or carbon steel	Ferroferric Oxide Protective Film
E-PFXHB			Electroless Nickel Plating
E-SFXHB		Austenitic stainless steel	－
E-PHFXHB		Tempered steel hardness HRC30～	Electroless Nickel Plating

If there are requirements for rust prevention, give priority to products made of austenitic stainless steel and with surface treatment of electroless nickel plating.

Part Number		Dg7		1mm increments		MA (Coarse Thread) Selection									M (Coarse Thread)	H	W
Type	No.			Y	F
E-FXHB E-PFXHB E-SFXHB E-PHFXHB	6	6	- 0.004 - 0.016	2~60	5~100	3									M 3	10	8
	8	8	- 0.005 - 0.020				4								M 4	12	10
	10	10					4	5	6						M 6	15	13
	12	12	- 0.006 - 0.024		10~150			5	6	8					M 8	17	14
	13	13														18	15
	15	15							6	8	10				M10	20	17
	16	16														21	18
	17	17														23	20
	18	18
	20	20	- 0.007 - 0.028	4~75					6	8	10	12			M12	26	24

 

D	M	t
6	M 3	11
8	M 4	12.5
10	M 6	14
12・13	M 8	17
15	M10	20
16
17
18
20	M12	25

Please select Y and F so that t dimension in the drawing is no less than the value shown in the above table.
When the pilot hole interferes, it goes through.

Feature 1: It has a tolerance of g7 and is used in conjunction with idlers, pulleys, sprockets, etc.
Feature 2: Products made of stainless steel (austenitic stainless steel) with excellent anti-rust performance and products with the surface treatment of electroless nickel plating are available for selection to solve the problem of rusting.
Feature 3: Freely selectable in 1mm increments to accommodate different use environments.

①Anti-rust specification selection and maintenance
If there are requirements for rust prevention, give priority to products made of austenitic stainless steel and with surface treatment of electroless nickel plating.
 Products without surface treatment need to be applied antirust oil regularly for maintenance.
②For dimensions of male thread relief groove, refer to the Specification Table.

For anti-rust performance of metal materials and surface treatment, refer to Anti-Rust Performance
For applicable tightening torque for the bolts, refer to Tightening Torque
For strength of bolt, refer to Bolt Strength