Bushings for Inspection Jig, Shouldered, Slotted, Dowel Pin/D Cut
:
MISUMI
Dimensional Drawing
Material Specification
| [ M ] Material | [ H ] Hardness | Shouldered Type | ||
| Type | Material Code | |||
| Rotation Stopper Type | Alloy tool steel or bearing steel | 50HRC~ | (P＋0.03 ＋0.01/W＋0.03 ＋0.01) E-KJB (PH8/WH8) E-KJBH | STC |
| Austenitic stainless steel | - | STCS | ||
| Martensitic stainless steel | 45HRC～ | STCC | ||
| Single Side Cut Type | Alloy tool steel or bearing steel | 50HRC~ | (P＋0.03 ＋0.01/W＋0.03 ＋0.01) E-KJB (PH8/WH8) E-KJBH | STCD |
| Martensitic stainless steel | 45HRC~ | STCDC | ||
Specification Table
Please select 1 item from Type, Material Code and D Dimension respectively (For details, refer to the Ordering Example below).
[ ! ]3 Only shouldered type is applicable to D＝8.
| Part Number | Common to all models | Only Shouldered Type | |||||||||
| Type | Material Code | D | 0.01mm increments | L | R | T | H | ||||
| Shouldered/Rotation Stopper Type | Shouldered/Single Side Cut Type | P | W | 1mm increments | Selection | ||||||
| (P＋0.03 ＋0.01/W＋0.03 ＋0.01) E-KJB (PH8/WH8) E-KJBH | STC STCS STCC | STCD STCDC | 8[ ! ]3 | 4.00~6.00 | P＞W (W≥3.00) | (Shouldered) 10~20 | 2.0 | 2 | 3 | 5 | D＋4 |
| 10 | 4.00~8.00 | ||||||||||
| 12 | 4.00~10.00 | ||||||||||
| 16 | 6.00~14.00 | ||||||||||
| 20 | 10.00~18.00 | ||||||||||
| 25 | 14.00~22.00 | ||||||||||
| P, W | H8 |
| 3.00~6.00 | 0 -0.014 |
| 6.01~10.00 | 0 -0.018 |
| 10.01~18.00 | 0 -0.022 |
| 18.01~27.00 | 0 -0.027 |
If there are requirements for rust prevention, give priority to the hard-chrome plated products, products with surface treatment of electroless nickel plating or products made of stainless steel.