Sliding Door Dedicated Frames

MISUMI

Economy Series Profiles, with different cross-sectional shapes and groove width sizes, can only be matched with Economy Series special accessories starting with L.
For some items with length over 2800mm, please email to "machinery_bd@misumi.com.vn" to check ability to supply.

This is an economy item, The price is cheaper than the MISUMI standard product.

Product Overview

Economy Series Aluminum Frame for Sliding Door
It is suitabule for Door and Windows

Dimensional Drawing

Type	Material	Surface Treatment
LSDF-2	6063-T5	Clear Anodize
LSDF-3	6063-T5	Clear Anodize

Specification Table

		Part Number	－	L
		LSDF2	－	1000

Part Number	Overall Length L mm	Profile Type	Mass kg/m
LSDF-2	50～2000(2500)	2 Slots	0.56
LSDF-3	50～2000(2500)	3 Slots	0.73

Maximum selectable length can be checked on configure bar on the left.

Alterations

		Part Number	－	L	－	（LTP·RTP·TPW）
		LSDF-2	－	1000	－	LTP

45°Degree Cutting is available.

Alteration	Alteration Symbol	Specification	Machining/Corrensponding Accesories
End Tapping (Center Hole)	LTP/RTP/TPW		Tapping holes on the end face of aluminum profiles Parts used for this additional processing： Button Head Screws
45-Degree Cutting	L□T45/R□T45		Cutting with 45-degree angle.
Drilling Wrench Hole	LWP/RWP		Drilling Wrench holes in fxed positions for Blind joint connections. Parts used for this additional processing： Button Head Screws
Counterboring	Z8/XA		Machining Counterbored holes at any specified positions. Parts used for this additional processing： Button Head Screws
S Hole Blind Joint Dedicated	LSH/RSH		Adding S holes for Pre-Assembly Insertion Double Joint connections. Parts used for this additional processing： Blind Joints, Pre-Assembly Insertion Double Joint Kits
M Hole Blind Joint Dedicated	LMH/RMH		Adding M holes for Post- Assembly Insertion Double Joints,Center Joint connections. Parts used for this additional processing： Blind Joints, Pre-Assembly Insertion Center Joint Kits

Product Features

1. Implement the GB industrial aluminum profile standard, 8~10μ anodized treatment, the surface is scratch-resistant.
2. A protective film is attached to the surface of the profile to prevent friction and damage during transportation.
3. Any length can be specified within the range of 50mm~2000(2500) for cutting.
4. Compatible with various alterations such as drilling and chamfering.
5. Economy Series profiles are different from Misumi’s existing profile cross-sectional shape

Precautions

1. The surface of the profile is covered with a protective film, and there may be a small amount of aluminum chips remaining, which is not a quality problem.
2. Economy series products are different from MISUMI existing profiles in section shapes, so they can only be used with Economy series special accessories starting with L.

Accessories	Part Recommended 1	Part Recommended 2	Part Recommended 3	Part Recommended 4
Nut	LNTN8-30-6-100P	LNHRN8-30-6-100P	LNSN8-30-6-100P	LTTB8-8-20-100P