4560, Slot Width 10mm Aluminum Frames

■Specified Length

Type

Profile

Overall Length L mm

Profile Type

Mass kg/m

Cross Sectional Moment of inertia

Recommend bracket and accessories 1

Recommend bracket and accessories 2

lx（cm4）

ly（cm4）

Standard Bracket

Bolt

Nut

Heavy load bracket

Bolt

Nut

LCF10

4560

50～2000 (2500)

Standard

2.52

26.72

16.01

LBSBL10-4545

E-GSCB8-18

LNHRN10-45-8

LBL5050-45

E-GSCB8-18

LNHRN10-45-8

LCFW10

Heavy Duty

2.9

30.09

17.79

Maximum selectable length can be checked on configure bar on the left.

Alteration	Alteration Symbol	Specification	Machining/Corresponding Accessories
End Tapping (Center Hole)	LTP/RTP/TPW		Tapping holes on the end face of aluminum profiles Parts used for this additional processing: Button Head Screws
45-Degree Cutting	L□T45/R□T45		Cutting with 45-degree angle.
Drilling Wrench Hole	LWP/RWP		Drilling Wrench holes in fixed positions for Blind joint connections. Parts used for this additional processing: Button Head Screws Joint Screw Plates
Counterboring	Z8/XA		Machining Counterbored holes at any specified positions. Parts used for this additional processing: Button Head Screws
S Hole Blind Joint Dedicated	LSH/RSH		Adding S holes for Pre-Assembly Insertion Double Joint connections. Parts used for this additional processing Blind Joints, Pre-Assembly Insertion Double Joint Kits
M Hole Blind Joint Dedicated	LMH/RMH		Adding M holes for Post- Assembly Insertion Double Joints,Center Joint connections. Parts used for this additional processing: Blind Joints, Pre-Assembly Insertion Center Joint Kits

1.Implement the GB industrial aluminum profile standard, 8~10μ anodized treatment, the surface is scratch-resistant.
2.A protective film is attached to the surface of the profile to prevent friction and damage during transportation.
3.Any length can be specified within the range of 50mm~2000(2500) for  cutting.
4.Compatible with various alterations such as drilling and chamfering.
5.Economy Series profiles are different from Misumi’s existing profile cross-sectional shape, and the specifications are compared as follows:With 4560 series profiles, small frames, hoods, racks and other modules can be easily completed for automation equipment.
1.The surface of the profile is covered with a protective film, and there may be a small amount of aluminum chips remaining, which is not a quality problem. 
After the film is removed, the aluminum chips will be removed.
2.Economy series products are different from MISUMI existing profiles in section shapes, so they can only be used with Economy series special accessories starting with L.