Linear Shafts-One Ends Threaded
:
MISUMI
[Features] Direct-acting shafts (linear shafts, hardened shafts, guide shafts, slide shafts) are male threaded on one end, female threaded on one end with a drilled hole, and have a spanner groove.
| Type | [ M ]Material | [ H ]Hardness | [ S ]Surface Treatment | ||||
| With Wrench Flats | With Cross-Drilled Hole | ||||||
| D Tol. g6 | D Tol. h5 | D Tol. f8 | D Tol. g6 | D Tol. f8 | |||
| SFAZ | SFZU | - | SFZH | - | SUJ2 Equivalent | Effective Hardened Depth of Induction Hardening >> P.142 SUJ2 Equivalent 58HRC~ SUS440C or 13Cr stainless 56HRC~ | - |
| SSFAZ | SSFZU | - | SSFZH | - | SUS440C or 13Cr stainless | ||
| PSFAZ | PSFZU | - | PSFZH | - | SUJ2 Equivalent | Hard Chrome Plating - Plating Hardness: HV750 ~, Plating Thickness: 5µ or More | |
| PSSFAZ | PSSFZU | - | PSSFZH | - | SUS440C or 13Cr stainless | ||
| RSFAZ | - | - | RSFZH | - | SUJ2 Equivalent | Low Temp. Black Chrome Plating | |
| - | - | PSGGZ | - | PSGZH | S45C Equivalent | - | Hard Chrome Plating - Plating Hardness: HV750 ~, Plating Thickness: 10µ or More |
| - | - | PSSGGZ | - | SUS304 | |||
[ ! ]Annealing may lower hardness at wrench flats, cross-drilled hole and shaft end machined areas (effective thread length + approx. 10mm). >> P.142
[ ! ]Cross-drilled hole areas may be out of O.D. tolerances due to annealing-induced deformation.
[ ! ]L Dimension Tolerance, Circularity, Straightness, Perpendicularity, Concentricity and Changes in Hardness >> P.141
[ ! ]Features of Low Temp. Black Chrome Plating p1_156
Example
