Housing Units with Clamp Lever - Tall Blocks - Single/Double, Right/Left Clamp Lever

MISUMI

MISUMI original standard. Compared to the standard type, the type with a clamp lever allows the position of the workpiece to be adjusted.

Single, Right Lever

Single

Double

Single, Left Lever

Single

Double

* The linear shaft is clamped by the internal nut as the lever is rotated.

Type

Used Linear
Bushing

Housing

Collar/Thread

Used Clamp
Lever

Lever

Lever Thread

Nut

Operating Ambient
Temperature

Single, Right Lever

Single, Left Lever

[M] Material

[S] Surface Treatment

[M] Material

[S] Surface Treatment

[M] Material

Single

Double

Single

Double

LHSSC

LHSSWC

LHSLC

LHSLWC

LMU

Aluminum
Alloy

Clear Anodize
Treatment

SUS304 Equivalent

CLFSC

Zinc
Diecast

Baked Paint Finish

SUS303 Equivalent

Stainless Steel
(SUS)

−20 to 80°C

App. Example

With Clamp Lever
Linear Bushing
Single, Left Lever

With Clamp Lever
Linear Bushing
Single, Right Lever

■ Precautions for Use
·For installation, loosen the lever until the nut does not interfere with the shaft, then insert the shaft.
·Do not tighten the clamp without a shaft inserted. The linear bushing may be deformed and become unusable.
·Use as a temporary fixing device. Do not use as a permanent safety position holding device.

Compression

■Max. Thrust Load Test Method
The collar in the housing unit is tightened to the torque value(s) shown in the chart, then compressive load is applied with the tester.
The compressive load with which the shaft begins to move is defined as the Max. Thrust Load. * Max. thrust load of greased linear bushings was measured.